Autoplay

    Particle Photon Component Overview

    Hugh ElliottHugh Elliott

    Before powering up the Particle Photon we are going to look at what each of the components are on the board.

    particleParticle
    Code

    Code

    Become a Member to view code

    You must be a Member to view code

    Access all courses and lessons, track your progress, gain confidence and expertise.

    Become a Member
    and unlock code for this lesson
    Transcript

    Transcript

    Instructor: 00:00 First off, let's look at the primary components and the ones you'll use or reference the most.

    00:06 Reset button. Works as named. Briefly turn off your board and turn it back on.

    00:12 Setup button. Primarily you use setup to put your board into listening mode, which is how you pass WiFi credentials to your board.

    00:20 RGB LED. This is the board status LED. This LED gives you all of the information you'll need at a glance to know how your board is doing.

    00:31 On-board LED. The On-board LED is tied to the D7 pin. For the classic blink example, you start with this LED as there is no setup required to affect it.

    00:42 The pins. The Particle Photon has six analog pins, eight digital pins of voltage-in, voltage-out, two ground pins, two serial pins, a DAC, a wake up, a reset, and a battery pin. The analog and digital pins can also run double-duty in various capacities.

    01:00 That's it. Now you're ready to get started with your Particle Photon.

    Discuss

    Discuss